• SOLDERLESS COPPER BONDING - Provides a cold weld between rigid copper fittings and connectors.
• EASY TO USE:
  1. Clean the pipe and fitting with 60 grit abrasive and apply a thin bead around the inside leading edge of the fitting.
  2. Apply a thin bead around the entire leading edge of the outer diameter of the pipe in a wave pattern.
  3. Insert the pipe fully in the fitting and twist it once 90 to 180 degrees and then back again.*
• FAST CONNECTIONS - After 10 seconds, the bond cannot be pulled apart by hand. After 7 minutes, connections can be pressure tested to 200 P.S.I.
• STRONG - After 24 hours, connections can be tested to 500 P.S.I.
• RELIABLE - As durable and permanent as a solder connection. Just-For-Copper has been in commercial use since 1998 without a reported failure.
• 100% SEAL - Just-For-Copper flows throughout the entire surface as the copper pipe is inserted into the connector or fitting to provide a 100% seal every time.
• SAFE - Non-toxic and safe on drinking lines, Just-For-Copper has no taste or odor when cured.
• PROVEN - Exceeds plumbing code pressure specifications. Can be used on copper pipe up to 2"diameter.
• ECONOMICAL - Each bottle contains enough product to make 200 connections using 1/2" copper pipe.
• WIDE OPERATING TEMPERATURE RANGE - Performs from -40° to 240°F.
• APPLICATIONS - Can be used on all rigid copper pipes, fittings and connectors that carry water (including potable drinking water), as well as natural gas and LP gas. Just-For-Copper can also be used on air conditioning and refrigeration systems that do not get colder than -40°.
• NO HEAT DAMAGE OR DANGER - No fire or burn danger from soldering with a torch.

NOTE: Not for use on coiled copper pipe, threaded copper connections or pipe and fittings that have been damaged or bent.

* In applications where the connection cannot be twisted in the first 5 seconds, apply a thick bead of product around the inner leading edge of the connector or fitting and around the outer leading edge of the pipe. Using your finger, lightly spread the product over the entire inner surface of the fitting and outer bonding surface of the pipe. Now insert the pipe into the fitting without twisting.